Centring Boss (flange Clamping)

Investment cast 1.4308 stainless steel. ISO 4762 cap screw and ISO 4032 hex nut, stainless steel. From ø30 mm ISO 4017 hex head bolt, stainless steel. Version: Electropolished. Note: The tube clamps with diameters 30 and 40 mm have a silicone sleeve that protects the thread of the hex head screw from contamination and damage. On request: Clamping levers for tightening. Accessory: - Round and square tubes 29050

Micron hand tools are made of high quality stainless steel material. This 4 piece kit contains the cutter and Teflon cutting board used to pre punch the material and the 2 piece setting dies. Specially built to set Stimpson A 670 oblong grommets.

Quickrelease couplings for water pipes, oil lines, brake and clutch lines. The quickrelease couplings are always used when a very fast installation and removal of services is required. Areas of application are motorsport and aviation.

Rods for ball bushings and plain bearings Ø10, 12, 16, 20, 25, 30 et 40 mm Guide rods with tapping at both ends (except stainless steel just 1 side) 4 matters hardened steel, chromed steel, stainless steel 304L, hardened stainless steel Several lenghts and special length on request.