Guide with leadscrew

Lifting table for electric motor Fixing with its reinforced end for vertical using Drived by ballscrew or leadscrew Guided by 2 rods on ball bushings (or plain bearings in leadscrew version) Motor adaptation for lifting table These lifting tables are delivered without motor, but the adaptation of your motor can be done by us. Some adaptations are standard, especially for standard motors (NEMA17 or NEMA23), if the dimensions of your motor are not listed, contact us to check the feasibility of your motor adaptation from our rough parts. Presentation of the lifting tables to be motorized The trapezoidal screw version is irreversible and the axial precision is <0.15 mm (in practice 0,02 to 0,10 mm). The ballscrew version is reversible and the axial accuracy is <0.07 mm. The maxi stroke is 300 mm, and any intermediate stroke can be produced. Assembly of tables in XZ, YZ or XYZ systems For a crossed table XZ

Manual table with double carriage with reversed step (the 2 carriages move away or get closer) Driving by leadscrew Guided by 2 rods Interest of table with reversed step The two carriages move away or get closer symmetrically during the rotation of the trapezoidal screw thanks to right and lefthand thread, this allows for example to adjust the spacing of the outer guides of a conveyor according to the type of product transported. Precision and robustness of right and lefthand thread table The guidance is provided by 2 rods on 4 calibrated bronze bearings (reduced play) or 4 ball bushings for guidance without clearance. The guide length of long body tables (309N/P) allows to accept large loads and torques. The axial positioning accuracy of these tables is <0.15 mm (in practice 0.02 to 0.10 mm). But the blocking in position is done on the carriage, by pressure on a guide rod, so as to remove the axial play of the nut of the trapezoidal screw after blocking

Manual lifting table Driving by leadscrew Guided by 2 rods Interest of lifting table These tables can be fixed by only one end thanks to a reinforced sole, for vertical or offset applications (using the mobile body). This simplifies installation directly on a plate or directly on the body of another table no need to build a vertical structure to fix it. In the fixed body version, they also make it possible to fix a load at the end (on the end flange) the quality of the embedding of the guide rods in this flange guarantees reliability even in the event of a bulky load (example label printer). Indeed, the assembly presented on the photo below corresponds to the height and width adjustment application of a label printer on a conveyor. The printer is attached to the end of the horizontal table and the base of the vertical table is attached to the side of the conveyor. For XY crossed tables, the tables are mounted one on the other directly by the body (long body version only)

Positioning table for electric motor Guided by 2 rods on ball bushings Motor adaptation on linear table These ballscrew tables are delivered without motor, but the adaptation of your motor can be done by us. Some adaptations are standard, especially for standard motors (NEMA17 or NEMA23), if the dimensions of your motor are not listed, contact us to check the feasibility of your motor adaptation from our rough parts. Tables with ballscrew for motor The ballscrew is reversible and the axial precision of these tables is <0.07 mm. The maxi stroke is 400 mm, and any intermediate stroke can be produced. For a XY cross table, the tables are mounted on each other directly by the body with option 308922* (smooth holes are made in the body of a table). For less precise positioning applications, these tables are available with trapezoidal screw.