Military grade hydraulic cylinders

Weight: 19,69 kg; Working/Test pressure: 16 MPa / 20 MPa; Outer diameter of the cylinder: 95 mm; Hydraulic connector: M22*1,5; Required volume of oil: 2 L; Start pressure: 0,5 MPa; Piston extension/retraction speed: 0,5m/s; Permissible ambient temperature: -40 to +60℃; Permissible oil temperature: -15 to +80℃; Type of gland: threaded, screwed into the tube; Piston rod chrome-plated: 20µm; Type of fluid: mineral oil based hydraulic fluid;

easy adjustment for different stock widths and lubricants lubricant dispensation from the inside thru hollow axles – for an even spread series RB SF SW top roll adjustment with pneumatic cylinder

1. NBR shaft seals on hardened cylinder barrels Drum motors axles are usually manufactured from ST37. Commercially available seals rotate directly on the axles. The result, at some point in time, is grooves on the axle. In addition of course oil leaks. This is not the case with the FTK Förderband Technik Kilian pulley motors all drum motors are equipped with hardened and polished cylinder barrels made of stainless steel 316. 2. Oil loss is not a problem for us! Oil change after 50,000 hours of work. Today, for reasons of cost, fewer and fewer users concern themselves with plant maintenance. The maintenance of complex plants is mainly carried out by outside specialists. Simple prefabricated parts, however, are usually used till worn out. This is also the case with drum motors. We have made allowance for this behaviour. The FTK Förderband Technik Kilian drum motors only require an oil change after 50,000 hours of work. In the case of operation with 3 shifts for example

Drived by integrated pneumatic cylinder Guided by 2 rods on ball bushings Adjustable mechanical stops Hydraulic shock absorbers Inductive sensors Flow limitation Compact and robust manipulator With a compact and very robust design, they are suitable for shortstroke movement where rigidity is necessary. They are often used in vertical or lifting modules in the design of pneumatic handling assemblies. For longer strokes, use the Type 37 manipulators. Several mounting directions possible Equipped with the same end plates and without exceeding of the cylinder at the end of the stroke, these compact manipulators can be fixed by the 2 end plates to have the movable central body, but they can also be fixed by the body, the rod cylinder can then be oriented up or down. Optimized end of stroke adjustments The fine adjustment of the stroke is done by mechanical stops without any intervention on the hydraulic dampers and the inductive detectors this saves time