Finland
Manufacturer/ Producer
SmartLift CASA 1000 is a new innovative lift for residential use. It can be installed indoor for maximum lift height up to 1000 mm as well as outdoor. It is suitable for places where you need a lift for wheelchairs but dont want the lift to take up much floor space. This lift takes up only around 34 cm x 113 cm and the controlbox including hydraulic pump and electricity can be placed on a separate place, even several meters away. The lifting frame and body is zinced and on top of that it is also powder coated and heated up. This treatment makes it to resist different chemicals and of course moisture and water without corrosion. Same treatment is used on lifts for pools. Also the electrical and hydraulic unit are placed in IP rated enclosures, and depending on the need, the IP rating of these enclosures and controls can be as high as IP67. This SmartLift Casa 1000 is operating on 230V AC but this means this electrical power is used only for charging the 12V 60A battery. If you need it to operate on 110VAC we can simply replace the batterycharger into that voltage. The hydraulic pump operates from a 12V 60A batterypack that operates even with no charging attached to it making it independent in power failure situations. When power from utility comes back, the battery will again go back to charging mode and you have soon a full battery charged. Upon request we can made different brackets for the hydraulic unit as well as fence/ gate if needed. Contact us, we are here to help you
Turkey
Developed for feeding systems of poultry farms, PX/PPC series are preferred thanks to their silent and trouble-free operations and lightweight structures.
Request for a quoteTurkey
These series which are provided in foot- (PA) and flange (PF) mounted options serve up in drive systems that need wide reduction ratio and maximum 26900 Nm of output moment.
Request for a quoteTurkey
The rotation of high speed shaft should not be more than 1500 rpm; The circumferential velocity of gear tranmission should not be more than 20 m/sec; The temperature of work environment should be -40-45°C. If it below 0°C, before start, the lubricating oil should be pre-heated to above 0°C. This speed reducer can be run at clockwise and counterclockwise direction.
Request for a quoteTurkey
Helical and worm gear units with 90° input and output axis range. Casing with feet, flange F options Rigid case structure and suitable for heat transfer. System resistance calculations are made in accordance with ISO, DIN and NIEMANN standards. Different input options may be provided (Coupled motor, IEC, PAM, W, Servo motor connected, ...). Different output options available (Solid shaft, Hollow shaft, With shrink disc, ...).
Request for a quoteCreate one request and get multiple quotes form verified suppliers.