With rotary control, two-way switch and soft-catch. 2-wire connection (neutral conductor not required) Optimised for dimming of retrofit LED lamps (LEDi). For dimmable Retrofit-LEDs (LEDi). For dimmable Retrofit-LEDs (LEDi) with conventional or electronic transformers. For incandescent lamps, 230 V tungsten halogen lamps, low-voltage halogen lamps with conventional or electronic transformers and dimmable energy-saving halogen lamps. Mix operaton of LEDi with conventional loads possible. Via mode switch adjustable between leading edge control and trailing edge control. Low-noise level by MOSFET transistors. With electronic short-circuit protection. With electronic overload protection. With adjustable minimum brightness. Without cover plate. Rated voltage: 230 V~, + 10% / - 10% Rated frequency: 50 Hz/60 Hz Nominal power: 2 - 100 W/VA (retrofit LED loads). Nominal power: 10 - 250 W/VA (non-LED loads).
Germany
ABB repair, exchange & replacement parts for ABB IRC5 & S4 Pendants Since the start of 2018, we also supply reconditioned repairs as well as exchange and replacement parts for handheld robot control panels from the IRC5, IRC5P, S4, S4+, S4C+, S4P and S4P+ product ranges manufactured by ABB. During the repair process, we ensure that components that are better than the manufacturer's are installed in addition to the manufacturer's original parts. As a preventative measure we also replace any components that are subject to ageing or use related wear. In addition to using components approved by the manufacturer or legislator, we test the reconditioned ABB handheld control panels with original IRB ABB robots under conditions that correspond to the actual working environment. We can therefore also provide an 24 month warranty* on the complete ABB handheld control panel.
Request for a quoteGermany
We offer a large standard assortment of high-quality tactile short-stroke switches or micro switches and micro switches. The switches and pushbuttons are characterised by a high level of workmanship and a long service life (up to 1 million cycles). The microswitches are used in medical technology, industry, entertainment technology and in the automotive sector and are suitable for PCB assembly. They are supplied on a roll. If your desired specification is not available in our standard range, please feel free to contact us at any time. Completely customised developments are also possible.
Request for a quoteGermany
The electronic temperature switch of BEDIA is fitted with thin-film resistor Pt 1000 in a bridge circuit. This sensor element provides close switch point tolerances and a quick response. Switch point and reset hysteresis may be selected within the admissible operating range when ordering so as to allow the monitoring of both very wide and very close temperature ranges. The switching output is protected from short-circuit and overload. The short-circuit current is limited by the output transistor switching off inthe event of a fault. It will automatically reset as soon as the fault has been remedied. The switch is available with ground-connected, plus-connected or potential-free DC switching output. The switch is open in the event of power failure or disconnection of the power supply, independed of the switching function. It is available both as normally open (NO) or normally closed (NC) switch.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.