Analog indicator NIQ31 / 360°

This is an essential onboard instrument to adjust the seaming rolls and the seaming chucks and set them at the same height. It is equipped with a digital and analogue indicator to guarantee precise measurement.

The new strain gage amplifier with IO-Link interface enables digitalization of the measurement technology right from the sensor. Its compact design and high degree of protection allow the instrumentation amplifier to be used practically anywhere in the field. Strain gage sensors typically have an output voltage of a few millivolts. In industrial environments, e.g. in the vicinity of electric motors or frequency converters, interference can affect the measurement result when transmitting analog signals. This is reliably avoided using the new strain gage amplifier with IO-Link interface. The analog link between the sensor and instrumentation amplifier is kept as short as possible, the standardized IO-Link communication is fully digital and interference-free. The amplifier is powered directly via the IO-Link interface – a standardized 5-wire cable with M12 socket. Strain gage sensors can be connected via a 4-pin M8 connector.

The T610 is a handheld measuring instrument from the Trotec MultiMeasure family, used for quick non-destructive moisture measurement up to 300 mm. Another advantage of the process, aside from the measuring depth, is its independence from the level of salt content in the material. This creates no dissimilarity to the microwave technique, whether it is an older or a new building being gauged. Since the unit’s screen can show two values, for purposes of results evaluation, a function value can be indicated at the same time as the present measured value, if needed. The T610 moisture meter can be linked to a PC through a USB cable. Due to the MultiMeasure Studio Software, the gauged values of the device can be transported online and in real time to the PC. A few practical benefits: German industrial design in robust, premium two-component construction with IP54 type of protection

The CSN® type RCVoltage Dividers consist of a proven reliable and high accuracy resistivecapacitive voltage divider. These are used for voltage measurement for control and protection systems in HVDC links and research institutes. The base for our Voltage Dividers are metal wire resistor webs that have been embedded in epoxy resin under vacuum. In this way, optimal protection against external influences can be achieved. Depending on the installation requirements (outdoor or indoor application), special designs of the voltage dividers adapted on the site requirements are used. The insulation medium (air, N2, SF6) can be easily adapted to the special requirements of the application. Our CSN® RCVoltage Dividers are characterized by