ECU 99,9 % : Electrolytic is used as copper material with a conductivity of 58, electrode in erosion, high-low current panel and busbar in substations. Among our standard products: Rod, Sheet Plate, Straight pipe, Tube Coil, Box profile, Grounding rod - plate, Roofing, Copper fittings and thin wires. Also, sheet plate measurements which do not have a standard are brought to necessary measurement by forging at desired dimensions. Parts that require CU-Cr-Zr (Chromium alloy) High electricity conductivity, hardness and strength at high temperatures: Are used as point welding electrode and seam welding disc at the source of low carbon steels (Panel radiator, Gasoline warehouse, etc.) and Galvanized steel plate (Automotive and white goods), electrode holder at spot welding machines, plunger electrode at erosion machines and contact busbar at substations.
Turkey
It has similar application areas with PVC. It has chemical resistance to acids and bases. It features weldability. Weldability is more difficult than PVC but more resistant weld seams are obtained. It has higher temperature resistance than polyethylene and PVC. Cost is low and economical since its density is very low. It has a high impact resistance. It can be used on section plates. Mechanical strength values are better compared to Polyethylene.
Request for a quoteTurkey
Textile industry, Confection, Automotive, Heavy industry (Iron-Steel industry), Agricultural sector and Machinery manufacturing, PLATE DIMENSIONS: 850 x 1170, 1000 x 2000 PLATE THICKNESSES: 0,50, 100 mm FENOL FIBER BAR : Ø 8 - 200 mm are available. Their lengths is 1000 mm. PERTINAKS PLATES AREAS OF USE : Electrical insulation, Printing machines, Textile industry, Automotive industry. PLATE DIMENSIONS: 850 x 1170, 1000 x 2000 PLATE THICKNESSES: 0,50, 50 mm VULCANIZED FIBER PLASTICS AREAS OF USE : Textile industry, Automotive, Electronics and other fields. FIELDS OF APPLICATION : Textile (in cotton yarn collection bins in programmed machines) Water armatures, Gasket making, Weak current insulation, Manufacture of agricultural sector machines.
Request for a quoteTurkey
It is a material with a high resistance to chemicals. Its specific weight is low. It is a slippery material with a low coefficient of friction. The water and moisture absorption property is close to zero. It can be used as cutting plate especially in industrial kitchens and butcher cutting log. It has the ability to be welded. The element that characterizes polyethylene is the molecular weight. Low molecular weight can be grouped into three groups: low molecular weight (PE 300), high molecular weight (PE 500) and ultra high molecular weight (PE 1000).
Request for a quoteTurkey
It is a material widely used in machinery industry. It is a material with relatively hardness, rigidness, slippery and good mechanical strength values. There are various uses for its gear applications, including wheel construction. However, it is not as hard and abrasion resistant as Kestamid, not as slippery as Pom C. Its chemical strength is moderate, and it is resistant to some acids and bases. The polyamide 6 has the ability to collect water on its own. These features have pros and cons. Pros is that it increases the strength of the part against vibration and sudden impacts. This allzws the dynamic stresses that would otherwise occur during part use to be removed within itself. Cons is that it is difficult to achieve measurement stability in the material. In other words, the material is affected even by the moisture in the air and gets changes in the measurement. The tolerances must be observed before finishing the final processes of the part.
Request for a quote