The bearings we have defined so far are the basic types, which constant feature is the fact that they allow all-ways movements and rotation. However, movements can be limited in one or all ways, thus obtaining guided or fixed bearings, respectively. In the first case -guided bearings- the restriction is obtained by means of guides parallel to the supporting axe that allows movement. To make friction as low as possible, PTFE and stainless steel sheets are welded to the guides.
Turkey
Dampers play a crucial role in the functionality of industrial ductwork as they are designed to control the flow of air or flue-gas within the ducts. The primary purpose of most dampers is to act as shut-off dampers. This means they are either fully open or fully closed depending on the operational requirements. However, some dampers are specifically installed to modulate the gas flow, allowing them to function in various partially open positions. The variability in damper functionality caters to different operating scenarios and provides flexibility in managing the flow of air or flue-gas through the duct system.
Request for a quoteGermany
Crane Installations Energy capacity 450 Nm/cycle Stroke max. 62 mm For even more protection: The profile dampers from the TC range of the ACE TUBUS-Series can also be used as safety dampers. These maintenance-free, ready-to-install damping elements made of co-polyester elastomer have been specially developed for use in crane systems and fulfil the international industry standards OSHA and CMAA. In the special TC-S design, managed to achieve the spring rate required for crane systems with the unique dual concept. Whether TC-S or TC, this range of models represents a cost-effective solution with high energy absorption for energy management systems. The very small and light design of Ø 64 mm to Ø 176 mm progressively covers energy absorption within a range of 450 Nm to 17,810 Nm.
Request for a quotePoland
Flat duct connector with damper made of white ABS plastic. The damper regulates the air flow in the ventilation system. It is available with dimensions of 110x55mm. It connects the flat D/P elements of the ventilation system. The elements of the ducts are joined using the "push-in" method without the need for sealing. Element made in Poland. 50 years of DOSPEL experience in production is a guarantee of the highest quality.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.