Not bleed valves (without flamearrester) KITO EV/o-...

Within the family of pressureregulating valves, a technical distinction is made between series of bypass valves, inline valves and threeway valves.

The pressure relief valves GEMÜ N085 and N185 protect the plant and the piping system against gauge pressure and reduces pressure peaks. The third pipe spigot enables the valve to be installed in the main pipe. If the pressure increases, the spring is raised and the valve opens. The pressure is reduced to the preset value and can escape via the third pipe spigot into an adjacent pipe. If the pressure falls, the spring force presses the diaphragm in the direction of the seal seat and it is closed. The spring force can be adjusted as required using a set screw. - Valve adjustments can also be made under working pressure. - The optimization of piston, springs and control face ensures good control characteristics - The actuator is hermetically separated from the medium

10 mm width, three different electrical connection possibilities. Optionally with manual override operation.

This compact motor valve is used in a wide range of process engineering control tasks. It is particularly characterised by its very short design. Most media such as steam, fluids, gases, etc. can be excellently controlled with it. This inexpensive version represents a real alternative to pneumatic actuators. Position electronics Analog stroke feedback Limit switch Fail safe feature . . .