Levelling wedges with adhesive anchor

Steel, nitrile rubber. Note: The low non-slip levelling wedge is suitable for loads of up to 2 tonnes. The levelling wedge provides a large support surface with a nubbed structure made of nitrile with a hardness of Shore 80. Using the flat angle of the wedges, the height of the levelling wedge can be adjusted by 0.15 mm per turn of the screw. The vulcanized non-slip layer provides durable insulation from vibrations, noise, and corrosive media.

Housing plastic. Ball bearing stainless steel 1.4112. Plain bearing insert POM. Bushes and grease nipple stainless steel 1.4301. Version Plain bearing insert white. Housing green. Stainless steel parts bright. Note The housings are very robust, hard wearing and shock proof. They are resistant to most alkaline solutions, weak acids (PH 49) and brines. In contrast to cast or steel housings the special plastic in these housings prevent the formation of microorganisms. Drawing reference 1) ball bearing 2) plain bearing

Unshielded system. The magnets can be mounted by pressfit or gluing. 1) magnetic face

Hardened to 780 ±40 HV 10 and ground. Without leadin groove. Note All bushes have the bore size marked on the upper face, e.g. 10. Diameters D1 over 15 mm increase in size by 0.5 mm. Dowels or coiled spring pins together with DIN 1731 flathead screws can be used in place of the stop pin.