OKS 400 – MoS₂ Multipurpose High-Performance Grease

Gearbox lubrication of heavily loaded, relatively slow-running toothed gearing when grease is used instead of oil due to leaks For heavily loaded and impact-loaded drives Chain lubrication, e.g. of hollow-pin chains in the conveyance and transport sector, for exposure to water and steam and at higher operating temperatures Bearing lubrication of friction and rolling bearings in annealing yards and drying systems, manipulators and robots, cooling-bed and conveyor systems, machines in food packing industry, steam sterilisers etc. Advantages and benefits Excellently suited for corrosive operating conditions with high operating temperatures and high pressure and impact loads Economical due to optimised formula Enables wear reduction, decreasing failure times and enabling long-term lubrication Long-acting, highly adhesive, temperature-stable and waterproof, noise-damping, impact and pressure resistant

Multipurpose oil for bearing, lever and joint lubrication Hydraulic oil for use in all areas in which physiologically harmless are required Compressor oil for piston compressors for prescribed oil ISO VG 100 Advantages and benefits NSF H1 registered Long economic operating times thanks to optimal additives against oxidation and ageing Good cold behaviour Resistant to cold and hot water, steam as well as disinfectants and cleaning agents For universal use due to long-term lubrication and high adhesive strength Good wear protection Tasteless and odourless Conforms to VDL requirements

Lubrication of dirt-sensitive sliding points in mechanisms Assembly lubrication with large lubricant reservoir, e.g. chucks in which a supplemental relubrication at longer intervals with grease guns is possible Advantages and benefits Excellently suited for dirt-free assembly and long-term lubrication Highly effective due to optimum solid lubricant combination Broad range of uses in area of parts sensitive to soiling Low consumption due to formation of highly effective lubricating films Good corrosion protection behaviour For best adhesion, clean contamination and other lubricants from thread and slide surfaces. Best way is to clean mechanically first (for example, with a wire brush) and then with OKS 2610 or OKS 2611 universal cleaning agent. Use a brush, spatula or similar to apply evenly a suitable quantity of paste to the head or nut contact surface and to the thread. The paste will also act as a sealant. Do not use paste instead of grease and mix only with suitable lubricants.

Grease lubrication of rolling and friction bearings, joints, linear drives and chains Lubrication of fittings, seals, moulded parts and elements of elastic rubber materials in the hot- and cold-water segment Lubrication of fittings or machines in dairies, breweries, bakeries, slaughterhouses, etc. Advantages and benefits NSF H1 registered Reduces wear Excellent resistance to oxidation and ageing Resistant to hot and cold water, water vapour, watery-alkaline and acidic disinfectants and cleaning agents