Orings are universal sealing elements used to seal against liquid or gaseous median. They are suitable for static and minor dynamic applications. Orings can be used for radial and axial sealing. The sealing occurs during installation by the radial or axial compression of the crosssection. During operation, the median pressure increases the deformation of the Oring and so increases the sealing effectiveness. For best sealing effectiveness, the Oring should have the largest possible crosssection. During installation the correct groove size, compaction, elongation/compression should be ensured. By static use the compaction should be 15 30% of the crosssection. By dynamic use it should be 10 18% (hydraulic), 4 12% (pneumatic). With regard to the ID, when installed the Oring should be stretched max 6% compressed max 3%
France
Elastomer NBR. Brace ring and tension spring steel. Rotary shaft lip seals are readytoinstall seals for sealing rotating shafts. They are made from an elastomer outer sleeve and an internal bracing shim. The tension spring ensures increased pressure of the lip against the shaft and supports static sealing. Form A DIN 3760 (ISO 6194/1) version, smooth OD. Form AS DIN 3760 (ISO 6194/0) version, smooth OD with extra dust lip to protect from external dirt. The material NBR has a high wear resistance and is resistant to motor fuels, oil, hydraulic oil and lubricating grease. Operating limits Circumferential speed (m/s) ≤12 Pressure (MPa/bar) ≤0.05/0.5 (rotary shaft lip seals are generally meant for unpressurised operation).
Request for a quoteFrance
Compact and light design, full loading on all sides. 4x safety factor against breakage in all loading axis. Rotatable 360°. Link swivel range max. 180°. The ball bearing allows the ring to rotate even under load. Lifting or securing loads, swivel rings have many uses. For the loading capacity to be valid it must be ensured that the ring is in line with the load. The swivel face must lie flat on the support beam and the screw must always be screwed in fully.
Request for a quoteFrance
For high demand hoisting and carrying tasks in safety-relevant areas (machine construction, load handling equipment, lifting tackle). The CE mark is impressed into the ring bolt. F2 permissible load under max. 45° per ring bolt. On request: Certificate of conformity.
Request for a quoteFrance
Self-aligning pads are used to support and clamp unmachined and machined workpieces. They also serve as stops, supports and thrust pads in fixtures and toolmaking. Ball secured against rotation. Form O: The abrasive diamond surface is bonded firmly to the ball. It is ideally suited to supporting smooth or slippery applications with a minimum of clamping pressure. This allows the diamond particles to get a firm grip on a very small area with minimum damage to the surface. The diamond surface offers excellent wear resistance. Form P: The polyurethane surface is vulcanised firmly to the ball. It is abrasion-resistant and does not discolour. It offers optimum protection against damage to delicate surfaces. The pearl-like surface gives a firm grip and allows air to escape so as to prevent any suction effect between the contact surface and the self-aligning pads. Advantages: The built-in O-ring holds the ball in place and keeps dirt and foreign particles out, ensuring uniform movement.
Request for a quote