Ring-Forcesensor "CCG"
Ringforce
Description
The CCG Series of annular load cells are designed for the measurement of compressive forces, both continually and periodically, and are often used in critical bolted installations to monitor bolt tension. They are also used in cable tension applications where they are mounted at the anchor point. Their low profile makes them ideal for use where space is limited. The CCG series can be entirely customised to meet your specific requirements, including the IP rating to IP68 for fully submersible applications and temperature range up to 200˚C. The CCG Series can be supplied complete with accompanying instrumentation with a UKAS traceable calibration service, please contact our technical sales team.
- Measurement and control instruments
- Forcesensor
- Ip Rating
Documents
Similar products from ETH MESSTECHNIK GMBH
ETH MESSTECHNIK GMBH
Germany
The SM71 series force sensors were specially developed for measuring clamping forces. The short measuring path of 0.019 - 0.14 mm (depending on the measuring range) and a natural frequency in the kHz range guarantee optimal results even for highly dynamic tasks. Typical applications include the simple determination of screw preloads, where the force sensor is used as a “measuring washer”. The very good reproducibility is less than one percent of the nominal load. The sensor is available in measuring ranges from 20 up to 2000 kN. Hardened washers are already included in the scope of delivery for quick and easy installation. The extremely simple and robust design is made entirely of stainless steel (protection class IP68).
ETH MESSTECHNIK GMBH
Germany
For disconnection of electrical power wrenches in connection with Value Master Base or GMV2 100 - 240 V / 50 - 60 Hz switching capacity approax16 A protection IP64 Safety plug
ETH MESSTECHNIK GMBH
Germany
For disconnection of electrical power wrenches in connection with GMV2 100 - 240 V / 50 - 60 Hz switching capacity approax 16 A protection IP40 Safety plug
ETH MESSTECHNIK GMBH
Germany
Digital built-in instrument for torque display 96 x 48 mm (B x H) optional: - Relais output - RS 232 interface - Analog output for active torquesensors The instruments PU5 are very versatile. They come standard with a 24-bit resolution, a measurement rate of 50 readings / s, a MIN / MAX memory, a 30 point linearization and an optical switch point indicator. Optionally, the instruments can be equipped with 4 free scalable setpoints, an analog output and a serial interface. They are 5 digits and is available in size 96x48. The sensor is supplied externally by a separate component.