Transport fan
Description
A fan designed for material transport is often a centrifugal fan with an impeller adapted for abrasive particles in the air flow. Fans that transport different materials in the air flow are often extra robust fans, with the right material in the cover and fan wheel. Depending on the application, the fan wheels can be equipped with knives that not only beat but also cut the transported material into smaller pieces, this type of fan is called a knife fan. By developing a fan for your particular application, we ensure that the fan can perform over time – regardless of how tough the application is. With a durable design with a stable fan curve, we know that our fans for material transport can help you with your particular application. Our many years of experience and large product range give our customers peace of mind. Development, design and manufacture of fans takes place with the highest precision and with the highest quality materials.
- Ventilators and fans - industrial
- Atex fan
- Smoke fan
Product characteristics
- Size
- On request
- Motor size
- On request
- Drive
- Direct-driven, belt-driven or coupled version
- Coating
- Primer, finish, hot-dip galvanizing, as desired
- Material
- Steel, aluminum, stainless steel, acid-resistant steel, special steel
- Special design
- With/without wear plates on impeller and with/without blades
Similar products from FLÄKTCOMP SWEDEN AB
FLÄKTCOMP SWEDEN AB
Sweden
ATEX fans are fans that are installed in environments where there is a risk that an explosive atmosphere can form. Therefore, these fans need to be designed according to the ATEX directives. Depending on the classification of the environment, internal solutions inside the fan, such as e.g. spark protection in the fan cover or non-sparking materials. While in other cases, EX-rated motors are also required. Explosive gases require special fans. Our factories are certified according to ATEX for the manufacture of fans for Zone 1 and 2 as well as for Zone 21 and 22 containing dust. The design, production and use of fans for explosive media or environment is clearly specified in Europe by standardized directives. To choose the right ATEX fan, one should start from operating data and process design, as well as whether there are any special requirements.
FLÄKTCOMP SWEDEN AB
Sweden
A smoke fan is a fan whose task is to operate under extreme heat conditions, usually in the event of a fire. Smoke fans are a very important part of many of today’s safety systems in tunnels and buildings. There are a variety of standards that smoke fans are classified within, it can e.g. be F200 Classification for operation at 200° C for 2 hours F300 Classification for operation at 300° C for 2 hours F400 Classification for operation at 400° C for 2 hours Our many years of experience and large product range give our customers peace of mind. Development, design and manufacture of fans for smoke gas is done with the highest precision and with the highest quality materials. A smoke fan can be designed as an axial fan or impulse fan. To choose the right smoke fan, you should start from operating data and system design, as well as whether there are any special requirements.
FLÄKTCOMP SWEDEN AB
Sweden
A flue gas fan is a fan that usually has the task of extracting flue gases from an industrial application, e.g. a melting furnace or pan. Flue gas fans are almost exclusively radial fans and transport not only clean air but also flue gases up to 550° C continuously. Flue gas fans are often a very important component in an industrial system. Our many years of experience and large product range give our customers peace of mind. Development. design and manufacture of fans for flue gas takes place with the highest precision and with the highest quality materials. In order to choose the right flue gas fan, one should start from operating data and system design, as well as whether there are any special requirements.
FLÄKTCOMP SWEDEN AB
Sweden
Sometimes spare parts are not enough and the entire fan (with or without motor) needs to be replaced. We can help you with all your existing fans. To make the exchange as accurate as possible, we want as much information as possible about e.g. operational data and media. A good start is usually to use the rating plate on your existing fan.