Triangle Maxi Edge Inspection Chamber Tmk R

Optigrun Edge Inspection Chamber RKS 80 for use on greened or gravelled roof areas above drains on edge areas directly before any ascending structural components.Especially suitable for use around edges in front of rising components Above rainage outlets for green or gravelled rooftops Can be connected to 3 strands of WLP Plus Triangle Water Conduit Inspection lid with entry seals Insulation wedge profile released from the back Walkable

Optigrun Triangle Maxi Inspection Chamber TMK suitable for negative pressure drainage. Combinable with Triangle and TSK water discharge systems. Drainage capacity for 2 % roof pitch and profiles connected to all four sides: 24 l/s. Extendable in 50 and 100 mm increments.

Special version of the Optigreen Triangle Maxi Inspection Cham-ber TMK with perforated intermediate floor to guide excess water from higher roof areas.For feeding and conveying excess water from rooftops located higher up to floors located lower down Conveys water through downpipes directly into a tie-in conduit with an open inlet at the top, e.g. in case of: Cascading drainage from smaller top floors, feeds roof drainage water from downpipes on façades into drainage levels of underground car parks or similar Can be connected to up to 6 WLP Plus and 3 TSK With perforated sheet metal intermediate partition Walkable

As a load distribution panel for the Optigrun system solution "Public Roof with Inspection Chamber". Including Optigrün Water Retention Box WRB 95 with corresponding cut-out.