aluPLUS

aluNORM was developed to protect electrical or electronic components. Due to the large number of standard sizes in four variants, the maximum level of product variety is guaranteed. Typical ROLEC single-channel mounting combines the screw channel for attachment to the wall with the one for closing the enclosure. This provides more space in the interior for your internal mounting. An EMC version is available for the AS and AD variants. This is also available for the AF and AH variants in the dimensions marked. Fastening domes in the lid and bottom enable simple installation of supporting rails, mounting plates, circuit boards and more. Matching cable glands are also available.

profiPANEL enables a total of eight mounting depths to be provided for. Thanks to this wide range of depths, profiPANEL therefore enables almost every conceivable configuration for the internal mounting of components to be realised. The enclosure front of the profiPANEL system is manufactured made-to-measure and provides for the almost edgeless and flush mounting of a front plate. Appropriate cut-outs for a display, switches and more are included in the service provided by ROLEC and are produced ex-works to meet customer specifications. The profiPANEL series includes two desk models for internal mounting. An ergonomically designed profile handle system is available for even more convenient handling, particularly with the deeper profile versions. There is also a 450-mm wide latching keyboard holder as an alternative to the desk, which can be enhanced and/or extended by an additional mouse holder.

technoPLUS is an advanced designer enclosure made from high-quality, UV-resistant Luran for electronic applications outdoors. The lid already has a recess to accommodate membrane keypads, films or touchpads. The screw channels are outside of the enclosure interior, thus allowing the enclosure to be attached while the lid is closed. The screw channels are simply covered with captive designer clips following assembly. Practical lid supports are available to provide strain relief on internal mountings in the lid. To enable use almost anywhere outdoors, technoPLUS comes with a practical mast support, which clings to virtually any curve. In the interior, there are fastening domes for the easy attachment of internal mountings. Compatible cable glands and other accessories are of course also available.

It is possible to directly integrate commercially available built-in panels in the front of the »multiPANEL KOMMANDO« enclosure. A small recess in the framework enables almost flush integration of the PC here. Furthermore, front plates can be inset in the frame from the front or rear, and fastened in place with clamping pieces. The combination of direct panel installation and a part front plate is also possible.With the flat multiPANEL 70 version, the rear wall is optionally available as a flush rear wall, which can be supplied with hinges and a lock or as a bolted version where required. A robust, 15mm deep, framed door including lock and internal hinges offers a greater installation depth. This results a multiPANEL enclosure depth of 85mm. Furthermore, a 60mm deep framed door version is also available for an even greater enclosure depth, which is also equipped with a lock and internal hinges. The total depth with this version is 130mm.