Cabinet Accessory

Micron hand tools are made of high quality stainless steel material. This 4 piece kit contains the cutter and Teflon cutting board used to pre punch the material and the 2 piece setting dies. Specially built to set Stimpson A 670 oblong grommets.

Steel C35Pb. Gunmetal Rg7. Plastic PA6.6 with MoS2). ISO trapezoidal thread based on DIN 103. Steel nuts for adjustments during manual operation and as fastening nuts. Not advised for use with motorised drives due to the steelsteel material combination. Gunmetal nuts for motion drives with low and medium speed. By insufficient lubrication, gunmetal trapezoidal thread nuts on steel spindles have good dryrunning properties. Plastic nuts for lownoise motion drives. Good dryrunning properties. Tolerance class 7H.

Quickrelease couplings for water pipes, oil lines, brake and clutch lines. The quickrelease couplings are always used when a very fast installation and removal of services is required. Areas of application are motorsport and aviation.

Worm screws, gear wheels, slide rails and other technical mouldings are today made of engineering plastics such as POM (polyoxymethylene), PA (polyamide) or PE (polyethylene). These materials with different property profiles (negative high water absorption with PA, poorer wear behaviour with PE) are supplied as sheets or rods. The required moulded parts are then produced by mechanical processing (turning, milling etc.) in a more or less complex manner. Effective injection moulding is only worthwhile for large quantities together with small component sizes, otherwise the high tool costs cannot be amortized. secutexTechno is characterised by high hardness (70° Shore D) and rigidity over a wide temperature range. It retains its high toughness down to 30 °C, has a high abrasion resistance and a low coefficient of friction. The intrinsic colour is yellow, making it well suited for technical applications. Mechanical processing is simple and comparable with other hard plastics.