With the purge air method, heat recovery for balanced air mass flows can be determined for alternating, decentralised ventilation units. The uncertainties of the direct measuring method used so far due to inhomogeneous velocity and temperature profiles at the outlet of the ventilation units are circumvented by the scavenging air method and the measuring accuracy is higher. With the optional humidity conditioning the moisture recovery can also be determined. Further thermal performance indicators are the air volume flow in alternating operation and the balance, which can also be determined with the test bench. The test stand is equipped with an auxiliary fan so that continuously operating ventilation units can also be measured with the direct measuring method.
China
Application SMT, BGA, CSP, Flip Chip, LED Detection, Semiconductor, Packaging components, Battery Industry, Electronic components, Automotive parts, Photo-voltaic, Aluminium Die-casting, Moulding Plastic. Ceramics, other special industries.
Request for a quoteGermany
Essential for direct reading and high-capacity torque wrench calibration! Mechanical loaders increase the accuracy ot torque test results while simultaneously reducing technician fatigue from pulling or pushing on torque wrenches during testing. A mechanical loader is the perfect accessory to increase the repeatability and productivity of the System 5 Digital Torque Tester. The drive system for each loader assures true 90-degree force application to eliminate force angle error in testing. In addition, the loaders mechanical advantage reduces technician effort and fatigue, particularly in high-capacity tool testing. SR Mechanical Loaders use the highest quality ball screws to assure smooth operation and extended service life. Welded steel frames and rigid transducer mounting plates assure torque load is properly resisted. Optimized gearing selection reduces physical effort to operate, enhancing productivity and ergonomic safety.
Request for a quoteGermany
A prerequisite for the adhesion of an adhesive or coating to a surface is wetting. For wetting to take place, the surface energy of the substrate must be greater than that of the coating. In particular, very many plastics have a very small surface energy and are correspondingly difficult to bond. Often the aim of a plasma treatment is to make a surface wettable and bondable. The wettability can easily be tested with test inks. Diener electronic supplies a test ink set with 8 liquids with surface tensions between 30 and 73 (105) mN/m suitable for most practical applications. There is also a set of 23 test inks, with additional gradations between 30 and 73 (105) mN/m.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.