IDG-DICHTUNGSTECHNIK GMBH

Suitable for nearly all fluids, Dry running possible, Low coefficient of friction, Very long life due to high abrasion resistance, No stickslip at low speed, Does not stick to the mating surface after prolonged shutdown, Nonsensitive to pressure peaks, Available in any diameter up to 700 mm 

Hydraulic and pneumatic cylinders, Presses, Shock absorbers, Fittings, Controls, Piston and plunger pumps, Mobile hydraulics, Injection units

Hydraulic and pneumatic cylinders, Presses, Shock absorbers, Fittings, Controls, Piston and plunger pumps, Mobile hydraulics, Injection units

Hydraulic and pneumatic cylinders, Presses, Shock absorbers, Fittings, Controls, Piston and plunger pumps, Mobile hydraulics, Injection units

The standard version is universally usable, but in special cases the light version can offer additional advantages. The light version is suitable for tight installation conditions and is also easier to fit in nonsplit grooves.This version reduces the friction. The low compression reserve with a negative effect on large tolerances must be considered.

Elastomeric wipers/scrapers are used in combination with the MANOY® sliding ring, the MANOY® U‑Cup or other rod seals.

The standard version is universally usable, but in special cases the light version can offer additional advantages.The light version is suitable for tight installation conditions and is also easier to fit in nonsplit grooves.This version reduces the friction. The low compression reserve with a negative effect on large tolerances must be considered.

Suitable aftertreatments can render precision O‑rings and X‑rings suitable for specific requirements. Typical requirements are low friction, easier installation (automatic or manual), lifelong lubrication, smooth running and non stick effect. Coating is a process frequently used for surface treatment. The IDG application consultants are available to discuss specific requirements with you.

Pivot pins are found on shutoff devices such as spherical valves, butterfly valves, hollow jet valves and plunger valves. These valves are generally used for opening and closing and occasionally to control the flow rates by oscillating movement. The greaselubricated sliding bearing is protected against water infiltration by a seal on the inside. The seal also prevents the grease leaking into the inside to prevent water contamination. The MANOY® system seal WP, type 418, was developed for this application. To prevent leakage of grease from greased bearings, the unidirectional MANOY® system seal WP, type 456, is also installed.

The guide vanes control the inflow of water in turbines. These vanes run in sliding bearings. To give the bearings longer term protection from water infiltration, the inner sealing MANOY® system seal WP, type 428, was developed for standard specifications. Type 487 with integral scraper was designed for high specifications due to abrasive constituents in the water and/or long inspection intervals. The housing for this seal must be open. The profile dimensions of both versions can be customized to adapt to existing groove designs.