Splined shafts at profile

Aluminium 6060 T5. Cover plug PA 6.6. Version: Black anodised. Colourless anodised. Note: These hinges have stainless steel tension springs which enables doors and hatches to open or close automatically. Opening angle 270°. Spring torque opening: M(0°): 0.7 Nm / M(90°): 0.5 Nm / M(180°): 0.3 Nm Fastened with DIN 7991 countersunk screws.

Spline shafts based on DIN ISO 14 with straight parallel flanks. A spline shaft with spline hub is used to transmit high torques while enabling simultaneous axial movement. The spline shafts are colddrawn. Cold drawing does not interrupt the grain flow of the base material, ensuring spline shafts of very high strength. Tolerances Straightness 0.8 mm/m. Torsion max. 0.5 mm/m. On request Other lengths.

Unshielded system. The magnets can be mounted by pressfit or gluing. 1) magnetic face

Hardened to 780 ±40 HV 10 and ground. Without leadin groove. Note All bushes have the bore size marked on the upper face, e.g. 10. Diameters D1 over 15 mm increase in size by 0.5 mm. Dowels or coiled spring pins together with DIN 1731 flathead screws can be used in place of the stop pin.