China
Manufacturer/ Producer
MAGR Program controllable Fluorescence Magnetic Partcle Inspection Series, best suited for locating surface and near-surface defects on automobile slewing journal, active bevel gear, axle journal, crankshafts, crankshafts, camshaft, halfshaft, streamboat axle shaft, aircarft landing gears, forgings and power generation parts ets. Our company, which has famous nondestructive testing experts, test equipment experts, nonstandard equipment design production experts, as well as technical person who are doctors or masters, in engaged in design production and research development of electromagnetism and acoustic emission equipment of nodestructive testing and nonstandard detection equipment and service.
Manufacturer/ Producer
E502,IER building,The South of The High-Tech park
518000 Shenzhen - China
Germany
Particular Challenges: In the course of the production, endless cables are running at a considerable speed, and supervision has to be carried out nearly under real-time conditions. The size of the objects to be determined, i.e. of the flaws to be discovered, is in the range of only some hundredths of a mm. Another difficulty is the fact that surfaces with very different reflectivity and roughness are involved. In order to be able to check the cables all around, several laser scanners must be in place, mounted at different angles, thus covering the entire range of 360°. Quelltech Solution: The solution consists in a configuration of four Q6 laser scanners, mutually displaced by 90°, so the entire surface of the cables is in the field of view. On the basis of the 100% inline inspection, the position of defects can precisely be determined, without losing too much time.
Request for a quoteGermany
The new QuellTech Q5 Laser Scanner Series combines the advantages of small form factors with both high resolution and scan rate. The sensor disposes of different set-up possibilities with respect to the analysis algorithm. Measurement results are delivered via Ethernet, calibrated in the X / Z plane. Special adjustable algorithms can be selected, extremely useful particularly also for optically most demanding surfaces. Time-consuming calibration tasks for the user are no more required, as the calibration routine runs on board. High Scan Rate with up to 14,000 Profiles per Second Due to an appropriate limitation of the image range (AOI) in X and Z direction, the scan rate could considerably be increased. High resolution and detection frequency with up to 14.000 profiles and 28 Mio. points per second •X measuring range from 10 to 1022 mm •Z measuring range (height) from 5 to 878 mm •Laser wave length blue 405/450nm, red 650nm
Request for a quoteGermany
Special version of the Optigreen Triangle Maxi Inspection Cham-ber TMK with perforated intermediate floor to guide excess water from higher roof areas.For feeding and conveying excess water from rooftops located higher up to floors located lower down Conveys water through downpipes directly into a tie-in conduit with an open inlet at the top, e.g. in case of: Cascading drainage from smaller top floors, feeds roof drainage water from downpipes on façades into drainage levels of underground car parks or similar Can be connected to up to 6 WLP Plus and 3 TSK With perforated sheet metal intermediate partition Walkable
Request for a quoteGermany
As a load distribution panel for the Optigrun system solution "Public Roof with Inspection Chamber". Including Optigrün Water Retention Box WRB 95 with corresponding cut-out.
Request for a quoteCreate one request and get multiple quotes form verified suppliers.