Magnetic tape scale with incremental coding 5 mm pole length

Housing polyamide 6. Hollow shaft steel. Screen plastic. Grub screw steel. Version Impactresistant housing. Hollow shaft black oxidised. Grub screw black. Dial black, digits white. Note Position indicators allow direct reading of input measurement values at a glance. In addition, the value indicated per spindle rotation (corresponding spindle pitch) can be selected and the various indicator values are realised by a transmission gear. The position indicators are distinguished by their small construction with very clear display. They are especially suitable for small spindle distances and small shaft diameters and have a torque support that is positioned in a hole on the side. ** At the 1st asterisk give assembly position and at the 2nd asterisk give the count direction (see sample order “assembly position, count direction”). Technical data – Counter consisting of 3 10position dials – Height of figures about 4 mm – Hollow shaft Ø 10 H7 mm

Housing aluminium. Cable sheath PVC. Version Compact sensor and plug design. Flat connector, 8pole, 1x pin. Connection cable, 6wire, ø 3.55–0.3 mm. Cable bend radius, > 17 mm (static). Note Works with magnetic tapes 21725. The reading distance between the sensor and tape must be 0.1 to 2 mm. The sensor is supplied with operating voltage and draws current via the electronics. System accuracy, repeat accuracy and travel speed is dependent on the electronics. Plugin connection to position indicators 21700 and 21702. Technical data Rating IP 67; EN 60529 (sensor head) Shock resistance 2000 m/s², 11 ms; EN 60068227 Vibration resistance 200 m/s², 50 Hz–2 kHz; EN 6006826 Temperature range Ambient temperature 0…60°C Storage temperature 10…70°C Assembly Installation must be carried out using the enclosed user information. A, reading distance sensor/tape ≤ 2 mm B, lateral offset ± 2 mm C, misalignment ± 3° D, pitch gradient ± 1° E, lateral gradient ± 3°

Outer jacket stainless steel. Cage stainless steel. Balls stainless steel. Note The linear ball bearings correspond to series 3 of ISO 10285. With doublesided seals and a stainless steel cage. The bearing is secured with DIN 471/472 circlips. Linear ball bearings with doublesided seals should be greased before installation. The specified load ratings apply with the use of hardened and ground shafts.

Bearing block and carriage aluminium alloy. Guide column and threaded spindle stainless steel. Plain bearing for guide columns and spindle nut highquality special plastic. Claw coupling aluminium with polyurethane coupling spider. Version Aluminium alloy anodised. Stainless steel hardened and ground. Threaded spindle with ball bearing. Note for ordering The unit is supplied with the position of cable outlet or control unit as shown in the drawing. Note Positioning stages for motorised adjustment and positioning tasks. The plain bearings and spindle nuts are suitable for dry running, however lubrication with a grease for plastic plain bearings is recommended. The suitable programming software and interface cable for the stepper motor with positioning control are available as accessories (2500015).