Shock absorbers - Import export

Industrial shock absorbers are maintenance-free, ready to install hydraulic components. They have an integrated fixed stop. The adjustable version enables precise adjustment to the desired dampening level. After installation, operate and adjust the shock absorber a few times until the desired braking level is achieved. Exceeding the max. energy intake per hour is possible if temporarily disconnected or the shock absorber is cooled with cylinder exhaust air. The installation position is arbitrary.

Body and flange plate EN AW5754. Guide shafts steel Version Body, hardcoated Flange plates, anodised. Guide shaft, hardened. Note Maintenancefree pneumatic linear modules with two precision steel shafts and ball guide bushing with wipers. Double acting cylinder drive. All fastening threads have threaded inserts. The as accessory available shock absorbers and proximity switches can be integrated (no protruding edges). Positive fit construction for hundred per cent reproducibility. Combinations in all sizes and stroke variants are feasible without adapter plates. Repeat accuracies of ±0.01 mm are possible. Specified loads apply by centred carriages. On request Available with locking cartridge as stroke deviation safeguard. Accessory See table for shock absorber, proximitiy switch and plug connector.

Outer body steel. Mounting bush plastic. Version: Steel electro zinc-plated. Note: Rotation dampers are maintenance-free, ready-to-install elements for the controlled braking and damping of rotational or linear movements. These rotation dampers enable the smooth opening and closing of small covers, compartments and drawers. They protect sensitive components and can also raise the quality and value of products. The rotation dampers brake right or left rotations or in both directions. One cycle rate corresponds to one 360° right rotation and one 360° left rotation. Attention: The rotation damper bush should not be used as a support, but rather as an external guide or bearing.

Round cord is widely used as a sealing filler cord, or to make Orings. Protective effect Shock absorbing Can be manufactured into Orings by vulcanization or glue

Agricultural equipment covers the production of radial shaft seals, cuffs, 0-rings, shock absorbers, protective caps, springs, fuel hoses and krimers. All products follow the EU norms. The produced articles for agricultural equipment should meet the following requirements: chemical stability in places of installation, deformation resistance when under pressure, breaking strength adapted to pressure, flexibility on low and high temperatures, resistant to attrition. In our production process of articles we use all well known types of elastomers.

SPECS: Surron Dirt eBike Dimensions 187 cm by 78 cm by 104 cm Weight 50 kg Acceleration 0-50 kph in 4 seconds Power Modes Eco, Sport Max. Speed 75 kph Max. Range 100 km (@20 kph) Max. Motor Power 5400W Battery Power 60V, 32Ah Lithium Battery Charging Time 3-4 hrs Climbing Angle 35 Degrees Water Resistance Motor: IP55 Controller: IP67 Colour Black, Silver, Blue, Grey, Red, Yellow, Green & Orange Minimum Clearance 27cm Seat Height 84cm to 88cm Motor Brushless Max. Torque 200 Nm Vehicle Material Aluminum Double Cradle Tyre Type Spoke Wheels, 19 x 1.4 Alloy Hubs Tyre Size 26-inch, 70/100-19 CST Brakes Front & Rear to the four-piston hydraulic disc Front Shock Absorber System Double Cylinder, Vertical Telescopic Rear Shock Absorber System Multi-Link Center Shock Drive System Belt + Chain The standard Light Bee is available with the X controller or the square wave controller.