Surge protective device SPD AC
SPD surge protection device AC surge protector device 400V 2P 4P
Description
NSPV surge protective device AC Surge protection device(SPD) is an indispensable device for lightning protection of electronic equipment. It is used to limit the instantaneous overvoltage of the power line and signal transmission line to the voltage range that the equipment or system can withstand, or A powerful lightning current drains into the ground to protect the protected equipment or system from impact and damage.
- Electrical & Electronic Components
- surge protective device
- surge protection device
- pv surge protective device
Product characteristics
- Model
- NSASPD-40
- Product
- AC2P SPD
- Test class according to
- IEC61643-1:2005 II
- Nominal voltage
- 230/400V, 50(60)Hz
- Rated voltage
- 385V
- Maximum discharge current (8/20μs)
- 40kA
- Nominal discharge current (8/20μs)
- 20kA
- Voltage protective level at In
- ≤1 8kV
- Type of Network
- TT-TN-IT
- Isolation resistance
- >10²MΩ
- Response time
- ≤25ns
- Recommended back-up fuse
- 125A
Documents
Similar products from NEWSUN PV TECHNOLOGY CO.,LTD
NEWSUN PV TECHNOLOGY CO.,LTD
China
NSPV surge protective device DC SPD protect against lightning surge voltages in solar system (photovoltaic power supply system). These units must be installed in parallel on the DC networks to be protected and provide common and different modes protection. Its installed location are recommended at both ends of the DC power supply line (solar panel side and inverter/converter side), especially if the line routing is external and long.High energy MOVs equipped with specific thermal disconnectors and related failure indicators.
NEWSUN PV TECHNOLOGY CO.,LTD
China
NSPV Solar fuse holder din rail 1000VDC NSDF38 type Features: Replaceable fuse; Flame retardant shell; A range of 10x38mm fuse links specifically designed for protecting photovoltaic strings; With mounting rails.
NEWSUN PV TECHNOLOGY CO.,LTD
China
● The junction box uses the PPE/PA,High rigidity, high temperature resistance chemical resistance, wear resistance and pollution resistance ● The junction box uses the glue to seal, the waterproof effect is better, the fitting interior heat is better. ● This junction box is a three-part design, and the cable adopts horizontal outlet mode, which can reduce the cable bending stress, save the cable usage, reduce the power loss of PV module, and divide the influence of "hot spot effect" into three parts. The influence of high temperature on photovoltaic modules is reduced. ● The diode and the terminal adopt an integrated packaging mode, and the terminal uses red copper
NEWSUN PV TECHNOLOGY CO.,LTD
China
NSPV MCCB DC The moulded case circuit breaker has the protection devices of over load, short circuit and under voltage, it can protect the circuit and power equipment from broken. The MCCB has the features of small volume, high breaking capacity, short electric arcing and anti-vibration. It is the ideal product for application in land and ship.