Workpiece stabiliser set with case

Workpiece supports are for supporting overhanging workpiece parts to prevent vibrations and bending during machining. They should not be subjected to strong forces from a clamping element and are not intended as supports under a clamping point.

Also called fixture clamps. The minimal height of this fixture clamp allows numerous clamping problems in fixture and equipment construction to be solved. The brass hex washer offers a gentle yet extremely stable and safe clamping of workpieces. By using several fixture clamps entire pallets can be set-up. “A” = distance from workpiece to screw centre (cam screw). On request: Replacement cam screws.

The double-sided clamp straps are ideal for series clamping. For special applications, the clamping flange can be replaced with another clamping flange by loosening the clamping screw. The clamping flange must always have a contact point on both sides. Functional principle: 1. Use a hand-held or electric tool to tighten the hexagon head bolt (make sure that the maximum tightening torque is not exceeded). When clamping, the clamping flange automatically turns by quarter of a rotation and starts the clamping stroke. 2. Use reverse procedure to loosen the hexagon head bolt. The clamping flange automatically returns to its starting position (the set screw can be used to change the position of the clamping flange). Drawing reference: 1) Hexagon head bolt 2) Slotted round nut 3) Set screw

Slide hammer tempered and chromed. Shaft, stop and guide sleeve hardened and chromed. Note: These extractors are used to remove locating pins and centring pins (03105, 03106, 03107, 03108, 03325) with M3 - M8 tapped holes. Drawing reference: 1) stop 2) slide hammer 3) shaft 4) cross pin 5) lock screw 6) guide sleeve 7) cap screw 8) 1 set guide sleeves